Side by side

What each one is good at

JobCNC router (us)Laser cutter
Plywood, MDF and form plyYes: ply to 25mm, MDF to 32mm, form ply to 17mm. Clean edge, no scorching.Thin sheet only, and the edge comes off dark and burnt.
Acrylic and perspexYes, to 20mm. Machined (matt) edge.Yes on thinner sheet, with a polished edge.
ACM / composite panelYes, to 4mm. This is what a router is made for.Not suitable.
Aluminium sheet and plateYes, to 16mm, including 5083 marine plate.Fibre laser shops cut aluminium sheet.
Steel and stainlessNo.Yes. This is laser, plasma or waterjet work.
Pockets, rebates and countersinksYes. A router cuts to a set depth as well as right through.No. A laser cuts through or marks the surface.
Sharp inside cornersInside corners keep a small radius, the size of the cutter.Very sharp inside corners.
Very fine detail in thin materialLimited by the cutter diameter.Better suited.
Big panelsUp to 2500 x 1500 in one piece.Depends on the shop.

Send it to us when

  • It is plywood, MDF, form ply, acrylic, ACM or aluminium.
  • The material is thick, or the panel is big.
  • You need holes, slots, pockets or rebates cut in the same job.
  • You want a clean timber edge with no burn marks.
  • You have no drawing. We can draw it from a sketch, a photo or the old part.

See what the router cuts →

Go to a laser shop when

  • The job is steel or stainless.
  • You need very fine detail or sharp inside corners in thin material.
  • You want a polished edge on clear acrylic.
  • It is engraving a photo or fine artwork onto a surface.

Not sure which you need? Send the job anyway and we will tell you straight if it is not one for us.

Recent Work

Off the Multicam

3D model of a square MDF peg board with a grid of 484 holes and a hand slot at each corner

18 November 2026

484-hole peg board in 18mm MDF

MR MDF 18mm Drawn from a sketch

A sketch turned into a 3D model and a dimensioned drawing: 484 holes on a 50 mm grid in an 1190 x 1190 sheet of 18mm moisture-resistant MDF, with four hand slots.

Read →
3D model of a wall sculpture made of 40 plywood ribs forming a rolling wave on a mounting board

16 November 2026

Wave wall sculpture: 40 plywood ribs

Marine ply 15mm 3D design check

A 1.8 m wave wall sculpture built in 3D from a set of drawings: 40 ribs in 15mm ply on a mounting board, plus one change we suggested to make it easier to assemble.

Read →
Batch of bolt template assemblies in 17mm form ply fitted with hold-down bolts, ready for delivery

30 May 2026

Bolt templates in form ply

Film face form ply 17mm Bolt template

Bolt templates cut from 17mm film face form ply for a local steel fabricator — they lock the hold-down bolt pattern in place during the concrete pour for steel columns on construction projects across Townsville and beyond.

Read →

See all recent work →

Send your drawing or a sketch and we'll quote within 24 hours.