← Recent Work

Wave wall sculpture: 40 plywood ribs

Marine ply 15mm 3D design check

The brief was a wall sculpture: 40 plywood ribs standing off a mounting board to make a rolling wave, 1800 mm long and 626 mm high. We built the whole piece in 3D from the drawings, all 40 ribs and the board, to check it would go together.

It did, with one catch. The grooves in the board set the spacing between the ribs, but nothing set the height of each rib, so all 40 would have had to be measured and held in place while the glue grabbed.

Our suggestion was a small notch in the back edge of every rib that drops over the board. Each rib hooks on at the right height by itself, and the board ends up hidden behind the ribs. Nothing changes in the look of the piece from the front.

Got drawings of your own? Send them through and we’ll check them and quote within 24 hours.

Front view of the wave sculpture modelThe wave sculpture model seen from above, showing how far the ribs stand off the wallDetail of the notch in the back edge of a rib that drops over the mounting board

Got a job like this? Send your DXF.